Features of direct solder dispensing with a dispenser

1. A dispenser can dispense solder to a minute part that cannot be supported with a metal mask.
   It can dispense solder to a 0402 minute component. (Minimum 50μm)
2. A dispenser performs additional soldering after printing.
   The dispenser optimum for your application can be selected.
3. Because any metal mask is not required, this dispenser is best suited to small amount various types production. (This operation can be supported with just change of a program.)

Applicable products: Twin-air, X-JET Piezojet dispenser

Twin-air: Best suited to fine dispensing to a minute component (Minimum dispensed diameter = φ50μm)

X-JET Piezojet dispenser: Effective use of non-contact dispensing feature for stable dispensing to a board that cannot be printed easily. (due to warpage or steric structure)

Dispensing to a line (Width 0.05 mm)